ghibb
Full Member
Posts: 28
|
Post by ghibb on Jun 23, 2013 22:19:02 GMT 12
Hi,looking at changing from stock mc on hq to dual wilwood mc,do you still have to have ome porpoising valve with warning switch in the line,seems like common sense to but is it required with dual master with two separate circuits ,regards
|
|
|
Post by Justin on Jul 5, 2013 10:37:57 GMT 12
Hi ghibb
Proportioning valves are not always needed, so are not a requirement as such, however unless the braking system components are all exactly matched so as to provide a perfect front to rear balance, a proportioning valve would normally still be required.
Justin
|
|
ghibb
Full Member
Posts: 28
|
Post by ghibb on Aug 27, 2013 20:12:30 GMT 12
Hi, it was more if I need to run stock valve with warning circuit , i have read brake warning devices were not required till 1978 by Australia standards is this correct for nz as well?, regards
|
|
|
Post by Justin on Sept 17, 2013 18:08:29 GMT 12
Hi there
A warning device should operate correctly if one is fitted, however there is no requirement for one to be fitted.
|
|