anton
Tyre kicker
Posts: 4
|
Post by anton on May 25, 2014 19:21:54 GMT 12
hi there so i have a datsun 1200 ute i am installing a rear irs eliminating the hole original leaf springs and diff, i have all the new system bolted in and rolling on wheels with all new adjustable suspension set up and camber adjustable parts, is it ok to have the xmember bolt up under the chassis of course strengthened plates welded around that area also?
also i was looking around at photos of other work of irs systems on cars, hot rods... is it possible just to eliminate the bolt up section of the xmember and just fully weld it up into the chassis making the hole thing a one piece unit, would be good to get some advise on this thanks
|
|