|
Post by harrytech on Feb 3, 2018 14:21:13 GMT 12
I have an aftermarket brake pedal profile cut out of 10mm steel with a tig welded tube in it for a brass bush, now based on where I have to mount it I really could do with some offset in it, what is the best way to bend it ? with a gas set or in a press.
|
|
|
Post by Todd on Feb 5, 2018 10:20:16 GMT 12
This is likely more of an engineering question than a certification one. There's no specific requirement for this, however an engineer may know what the best way to do this is, given the specific metal used etc.
|
|