|
Post by jeremiahnz on Jul 9, 2020 12:48:15 GMT 12
Hi,
I have performed a drum to disc conversion and need longer wheel studs. The previous studs were 7/16” however as the rotors are drilled to M12, I would like to get the axles/hubs drilled out slightly (by an engineering shop) to accept a M12 wheel stud. Is this something that can be certified?
It is an old car and replacing hubs/axles would be difficult as they are hard to find, so want to be sure first!
Thanks
|
|
|
Post by Chris on Jul 9, 2020 14:04:59 GMT 12
Hi, I have performed a drum to disc conversion and need longer wheel studs. The previous studs were 7/16” however as the rotors are drilled to M12, I would like to get the axles/hubs drilled out slightly (by an engineering shop) to accept a M12 wheel stud. Is this something that can be certified? It is an old car and replacing hubs/axles would be difficult as they are hard to find, so want to be sure first! Thanks No problems with what you are suggesting, providing it is modified in a tradesman-like manner.
|
|
|
Post by jeremiahnz on Jul 10, 2020 11:28:11 GMT 12
Thanks!
|
|