ghibb
Full Member
Posts: 28
|
Post by ghibb on Sept 2, 2021 22:54:10 GMT 12
hi,just read information sheet in regards to tierods, #4-202(v2 june 2021), states that aluminium cant be used for adjustment sleeves is this only if you make your own or does it include aftermarket products as well? regards
|
|
|
Post by Chris on Sept 3, 2021 10:51:59 GMT 12
hi,just read information sheet in regards to tierods, #4-202(v2 june 2021), states that aluminium cant be used for adjustment sleeves is this only if you make your own or does it include aftermarket products as well? regards Hi Ghibb It means all, aftermarket and custom made. Cheers
Chris
|
|
ghibb
Full Member
Posts: 28
|
Post by ghibb on Sept 3, 2021 21:33:05 GMT 12
Cheers
|
|
ghibb
Full Member
Posts: 28
|
Post by ghibb on Sept 5, 2021 19:07:40 GMT 12
Hi Chris, also in doc min recommended small end taper size of 13mm does this rule out eariy chev taper which is 12.3mm? would these need to be inlarged or changed to ford type? regards
|
|
|
Post by Chris on Sept 6, 2021 12:07:40 GMT 12
Hi Chris, also in doc min recommended small end taper size of 13mm does this rule out eariy chev taper which is 12.3mm? would these need to be inlarged or changed to ford type? regards Hi Ghibb The info sheet says that the major diameter must be a minimum of 16mm but the minor diameter is only recommended to be 13mm but no less than the OE size> I interpret this to mean that the minor diameter could be 12.3mm if that was the size that the vehicle came with from the factory, but the major must be at least 16mm. Hopefully that answers your question. Cheers
Chris
|
|
ghibb
Full Member
Posts: 28
|
Post by ghibb on Sept 8, 2021 23:02:24 GMT 12
pretty much voids any imperal 5/8 rod ends with .625 being 15.87mm or has this been rounded up as has the rod end tables 1/2 -12mm 5/8 -16mm?regards
|
|
|
Post by Chris on Sept 9, 2021 8:18:07 GMT 12
pretty much voids any imperal 5/8 rod ends with .625 being 15.87mm or has this been rounded up as has the rod end tables 1/2 -12mm 5/8 -16mm?regards Hi Ghibb, 5/8" rod ends are considered acceptable equivalents to 16mm. Chris
|
|